OK guys, I am giving up...

Thanks for all of you for your suggestions and your help!

Here, my last attempts to find a solution:

I tried to regenerate translator using AltList: m0,6,3,,,,,22 ----> "format successful" but 0LBA remains unchanged.

I started m0,6,4,,,,,22 to recover factory defect lists from factory selfscan logs; just after the start I get (not regular, but over and over) the same responce "LED:000000EE FAddr: 002829F8" Obviously a function with address 002829F8 returns general error "not successful." The last command m0,6,4,,,,,22 is running during the last 27 hours, should I breake this last run? or I am going a risk here to get irreparable damage of data?

Dear gurus who is familiar with this sort of problems and can take over?
Please PM me a short message.

Thanks in advance!

Many thanks to pcimage!

He solved this problem very fast and professional.

Thanks to all who was involved in this discussion.

Regards

Thanks

Not quite as straight forward as I'd imagined, but got it sorted!

_________________
PC Image Data Recovery
http://www.pcimage.co.uk

New!! HDD-PCB.COM for all your PCB and donor HDD requirements!

Good job pcimage

_________________
http://www.northwind.gr
SandForce SSD Recovery
Ransomware Reverse Engineering - NoMoreRansom! partners

So what did PCImage do in his PM that was different than your approach and solved your 7200.11 problem sector0,

Please advise..
Thanks!
Doug

I didn't do anything by PM, the drive was sent into our lab and I did it there

_________________
PC Image Data Recovery
http://www.pcimage.co.uk

New!! HDD-PCB.COM for all your PCB and donor HDD requirements!

Understood ... Good WORK I'd Say !

Thanks for the rapid response...

Doug