MultiDrive – free backup, clone & wipe disk utility from Atola Technology

All times are UTC - 5 hours [ DST ]




Post new topic Reply to topic  [ 7 posts ] 
Author Message
 Post subject: st31000524as
PostPosted: June 13th, 2013, 15:34 
Offline

Joined: August 16th, 2012, 4:57
Posts: 324
good evening .

st31000524as terminal log is


Boot 0x40M
Spin Up[0x00026F7C][0x000273E8][0x00027854]
Trans.

Rst 0x40M
MC Internal LPC Process
Spin Up
(P) SATA Reset

MCMainPOR: Start:
Check MCMT Version: Current
MCMainPOR: Non-Init Case
MC Seg Disc and Cache Nodes: 40125B28 40122F00
Seg Write Preamble VBM start: 0000204A end: 00002091
Footer - start: 00002093 end: 000020DA
Seg Read Preamble VBM - start: 000020DC end: 00002123
Footer - start: 00002125 end: 0000216C
Reconstruction: MCMT Reconstruction Start
Max number of MC segments 0A61
Nonvolatile MCMT sequence number 00473126
[RSRS] 05A5
Reconstruction: Completed 0: HeadPtr was unwritten
[MCMTWS]
MCMainPOR: MCTBufferPtr->Header.MCStateFlagsDisc = 00005141
MCMainPOR: MCTBufferPtr->Header.MCTStateFlags = 0000002A
MCMainPOR: MCStateFlags = 00005141

MCMainPOR: Feature Enabled...

Rst 0x40M
MC Internal LPC Process
Spin Up
LED:000000BD FAddr:000058E4
LED:000000BD FAddr:000058E4
LED:000000BD FAddr:000058E4

the drive doesn't detect at all ..

any help will be appreciated ..

thank you


Top
 Profile  
 
 Post subject: Re: st31000524as
PostPosted: June 13th, 2013, 16:54 
Offline

Joined: August 18th, 2010, 17:35
Posts: 3669
Location: Massachusetts, USA
Does not detect in what? or where?
It seem like you should be able to at least see ID. Firmware access, likely not yet.

_________________
Hard Disk Drive (HDD), Solid State Drive (SSD, SATA, NVMe, etc), USB Flash Drive and RAID Data Recovery Specialist in Massachusetts


Top
 Profile  
 
 Post subject: Re: st31000524as
PostPosted: June 14th, 2013, 16:25 
Offline

Joined: August 16th, 2012, 4:57
Posts: 324
labtech wrote:
Does not detect in what? or where?
It seem like you should be able to at least see ID. Firmware access, likely not yet.



drive doesn't detect on bios ..
and i can access asci mode if hitted ctrl+z before the

LED:000000BD FAddr:000058E4
LED:000000BD FAddr:000058E4
LED:000000BD FAddr:000058E4

start to appear , after they appear , ctrl+z will do nothing

thank you


Top
 Profile  
 
 Post subject: Re: st31000524as
PostPosted: June 14th, 2013, 19:14 
Offline

Joined: August 18th, 2010, 17:35
Posts: 3669
Location: Massachusetts, USA
What about drive behavior after power on? No odd sounds?
Try testing heads before the error message locks the drive.
Do NOT write anything to the drive or alter the firmware except SMART.
These can be difficult to recover.

_________________
Hard Disk Drive (HDD), Solid State Drive (SSD, SATA, NVMe, etc), USB Flash Drive and RAID Data Recovery Specialist in Massachusetts


Top
 Profile  
 
 Post subject: Re: st31000524as
PostPosted: June 15th, 2013, 9:46 
Offline

Joined: August 16th, 2012, 4:57
Posts: 324
labtech wrote:
What about drive behavior after power on? No odd sounds?
Try testing heads before the error message locks the drive.
Do NOT write anything to the drive or alter the firmware except SMART.
These can be difficult to recover.



thanks again for your reply ..

the data is not important , i just need the drive ..

no odd sounds , normal hdd initial behavior ..


Top
 Profile  
 
 Post subject: Re: st31000524as
PostPosted: June 15th, 2013, 11:46 
Offline

Joined: August 18th, 2010, 17:35
Posts: 3669
Location: Massachusetts, USA
In those circumstances there are few common things to try. Have been discussed on the forum a lot.

_________________
Hard Disk Drive (HDD), Solid State Drive (SSD, SATA, NVMe, etc), USB Flash Drive and RAID Data Recovery Specialist in Massachusetts


Top
 Profile  
 
 Post subject: Re: st31000524as
PostPosted: September 12th, 2013, 14:43 
Offline

Joined: July 6th, 2013, 15:13
Posts: 311
Location: ISLAMABAD
u need to find the pins to short then u able to repair the hdd.
mail me i tell u the procedure .
thanks
waqasali766@hotmail.com


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 7 posts ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 276 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group