MultiDrive – free backup, clone & wipe disk utility from Atola Technology

Main » Forums home » Conventional hard drives

All times are UTC - 5 hours [ DST ]



Post new topic Reply to topic  Page 1 of 1
  [ 3 posts ] 
  Previous topic | Next topic 
Author Message
solosdk
 Post subject: I need help from a PCB expert | Does this revision matter?
PostPosted: September 4th, 2013, 12:10 
Offline

Joined: August 31st, 2013, 8:12
Posts: 27
Location: United
Right I have a wd hard drive it failed on me.

I have two of the same hard drive

Failed hdd pcb no. is: 2060-771761-001 REV P1

2nd identical hdd pcb is: 2060-771761-001 REV A

Would the Revision code make a difference? Everything looks identical including the chip numbers etc

Say if i was to swap the 2nd pcb onto the first hdd, would it work?

Thanks
Top
 Profile  
 
solosdk
 Post subject: Re: I need help from a PCB expert | Does this revision matte
PostPosted: September 4th, 2013, 13:00 
Offline

Joined: August 31st, 2013, 8:12
Posts: 27
Location: United
Anyone?
Top
 Profile  
 
labtech
 Post subject: Re: I need help from a PCB expert | Does this revision matte
PostPosted: September 4th, 2013, 14:42 
Offline

Joined: August 18th, 2010, 17:35
Posts: 3669
Location: Massachusetts, USA
Rev should be ok, just swapping likely not ok.

_________________
Hard Disk Drive (HDD), Solid State Drive (SSD, SATA, NVMe, etc), USB Flash Drive and RAID Data Recovery Specialist in Massachusetts
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 3 posts ] 

Main » Forums home » Conventional hard drives

All times are UTC - 5 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 36 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Switch to mobile style
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group