Hello,

My backup hdd got burned (probably electrical surge or something similar), symptomps are: hdd wont spin, no clicks, total silent, there are no visible burns on PCB, no any smell.

I think the PCB is damaged, am I right ?

I ordered exact same PCB from ebay
Specs:
ST2000DL001
PN: 9VT156-570
FW: CC96
PCB: 100617465 REV A

- My questions are:

If all parameters are the same, will I need to do ROM swap to new pcb ?

Which one of chips should I swap (see attached picture), I have no idea, which one is the correct rom

8 legged chip, bottom right of pic

_________________
PC Image Data Recovery
http://www.pcimage.co.uk

New!! HDD-PCB.COM for all your PCB and donor HDD requirements!

So this is the one ?

Thanks for answer