June 13th, 2014, 14:40
Hi
Got this drive that can't ID...
After power on I get this:
Techno On............................... : Drive is not ready
Zone table.............................. : Zone table read error; Drive is not ready
G-List reading error.................... : G-List read error; Drive is not ready
CP Avalable............................. : 33,34,44,56,92,95,98,9A,9C,A2,A5,A7,A8,A9,AA,AD,AE ,B1,B3,BB,BF,C1,C5,C6,C7,C8,C9,CB,CD,D0,D1,D3,D4,D 6,D7,D9,DA,DB,DC,DD,EF,F1,F3,F4,F7,F8,FA,FB,FC,FF
The drive tries to calibrate (some very low noises) and sometimes can get Ready, other times, stay Busy.
Can this be only the G-list error?
I have tried to clean it, but I always get the drive Busy....
Thank You
June 13th, 2014, 17:04
Have you tried isolating Head Contacts ?
June 17th, 2014, 8:10
than most likely, media or head problem
June 17th, 2014, 8:29
Hello,
The Toshiba hdd stay busy because of continuous reading of bad area (Bad sector ) and assign it. when the damaged sector is read able then the hdd shows you ready status, some time it take about 30 minutes to become ready. after ready clear G list and extract data by cloning through MRT or pc3000.
Some times head or sub zones are damaged that's why it stay busy fro about 30 minute.
Regards
Waqas Ali
June 17th, 2014, 13:12
This is a FW problem (translator...) If I read thru utility on PC3K I can access data. The problem is that I don't have DE....
Still working on it.
June 17th, 2014, 15:02
Got it imaging finally eheheh
June 23rd, 2014, 4:55
Are you sure this was translator issue?
July 1st, 2014, 5:32
Yes, the case was closed with 100% recovery.
At least with this solution I could get the data.