hello

I have an seagate Momentus 7200.4 (ST9250410AS) 250Go and i can't use it because is smart tripped.
I not need this hdd, I want use to understand how it's work.

I open a stcom terminal
I sent /N1
and
"m0,2,2,0,0,0,0,22"

for me , N1 clear the smart data
and m0 'pre-format' the hdd (define ok or bad sector)

but of course if I post here.. that doesn't work

The smart is not more tripped

but the pre-format not seen to have work

What I need to do to totally 'rebuild' this disk ?
(i don't want to use it, just clear it, use it for test and see it become tripped after some time)

thanks

Throw it away and buy a Toshiba or HGST

If you want to learn more about the M command in terminal you should start here: https://www.data-medics.com/forum/viewt ... f=26&t=100

_________________
Data Medics - Hard Drive, SSD, and RAID Data Recovery Service Company

m0 command is only valid for extract data, not for use the drive commonly

Hello

thanks for your answer and the document.

This is my log :


Rst 0x10M
(P) SATA Reset
ASCII Diag mode

F3 T>i4,1,22

F3 T>m0,8,2,0,0,0,0,22
Max Wr Retries = 00, Max Rd Retries = 00, Max ECC T-Level = 00, Max Certify Rewrite Retries = 0000


and after one hour I have only :

LED:000000CE FAddr:0029D7F3
LED:000000CE FAddr:0029D7F3
LED:000000CE FAddr:0029D7F3
LED:000000CE FAddr:0029D7F3
LED:000000CE FAddr:0029D7F3
LED:000000CE FAddr:0029D7F3
LED:000000CE FAddr:0029D7F3
LED:000000CE FAddr:0029D7F3
LED:000000CE FAddr:0029D7F3
LED:000000CE FAddr:0029D7F3
LED:000000CE FAddr:0029D7F3
LED:000000CE FAddr:0029D7F3
LED:000000CE FAddr:0029D7F3
LED:000000CE FAddr:0029D7F3
LED:000000CE FAddr:0029D7F3
LED:000000CE FAddr:0029D7F3

and I DON'T have something like this :
"User Partition Format 10% complete, Zone 00, Pass 00, LBA 00004339, ErrCode 00000080, Elapsed Time 10 mins 00 secs "

since error seem to b always in the same address "0029D7F3"
can I modify number of retry in the m0 command line ?

If i modify only [MaxWrRetryCnt],[MaxRdRetryCnt] from 0 to 5 (for exemple) it could be good solution ?

thanks

REBUILD ALL :

F3 T>m0,2,1,,,,,22
F3 T>m0,2,2,,,,,22
F3 T>m0,2,3,,,,,22

your hdd can bad full , can't repair, i not repair seagate f3, build ----> repair----> error

RIP