MultiDrive – free backup, clone & wipe disk utility from Atola Technology

Main » Forums home » Flash storage, SSD

All times are UTC - 5 hours [ DST ]



Post new topic Reply to topic  Page 1 of 1
  [ 9 posts ] 
  Print view Previous topic | Next topic 
Author Message
Ronald111
 Post subject: Noname monolith
PostPosted: November 15th, 2015, 19:24 
Offline

Joined: July 21st, 2015, 23:21
Posts: 30
Location: Japan
Hi, everyone!
Please advise if the pinout of this monolith from Toshiba SD card might be the same as the one with the 27pin SD?


Attachments:
File comment: already with flux on it:)
IMG_7880.JPG
IMG_7880.JPG [ 242.21 KiB | Viewed 8397 times ]
Top
 Profile  
 
HaQue
 Post subject: Re: Noname monolith
PostPosted: November 15th, 2015, 20:15 
Offline
User avatar

Joined: December 4th, 2012, 1:35
Posts: 3903
Location: Adelaide, Australia
are you referring to SanDisk ones? if so then I don't know, but maybe test like the following:

Label each pin across as column a,b,c,d etc, and rows 1 and 2.

test pin F1 and see if it is VCC, and test pin K1 and see if it is GND.

if not, test with GND on SD pads, and find GND on test pins. see if pinout lines up at all.

the last 3 cols for the 27pin SD are for 16-bit bus, so you might be lucky.
Top
 Profile  
 
Ronald111
 Post subject: Re: Noname monolith
PostPosted: November 16th, 2015, 2:52 
Offline

Joined: July 21st, 2015, 23:21
Posts: 30
Location: Japan
Thank you for the reply!!! Will try :D
Top
 Profile  
 
arvika
 Post subject: Re: Noname monolith
PostPosted: November 16th, 2015, 3:42 
Offline

Joined: October 24th, 2009, 15:22
Posts: 917
Location: Poland
Make as Haque advice. What happen with card? After fire?

_________________
Flash Killer - everyday new resources (pinout, XOR, ECC,config) for flash devices
Top
 Profile  
 
HaQue
 Post subject: Re: Noname monolith
PostPosted: November 16th, 2015, 4:27 
Offline
User avatar

Joined: December 4th, 2012, 1:35
Posts: 3903
Location: Adelaide, Australia
No, I think it just has flux on it :)
Top
 Profile  
 
Ronald111
 Post subject: Re: Noname monolith
PostPosted: November 16th, 2015, 5:19 
Offline

Joined: July 21st, 2015, 23:21
Posts: 30
Location: Japan
Yep, it`s flux :D But the card itself was ridden over by a car several times and spent a day in water, but there`s no any visible damage. Do you think it is recoverable?
I tried to test the pins but no luck
Top
 Profile  
 
HaQue
 Post subject: Re: Noname monolith
PostPosted: November 16th, 2015, 5:54 
Offline
User avatar

Joined: December 4th, 2012, 1:35
Posts: 3903
Location: Adelaide, Australia
If you find the ground of the SD pins, using continuity test, are any of the test pins also Gnd? same with vcc?
Top
 Profile  
 
Ronald111
 Post subject: Re: Noname monolith
PostPosted: November 16th, 2015, 6:19 
Offline

Joined: July 21st, 2015, 23:21
Posts: 30
Location: Japan
I have found no GND or VCC, tested all the pins :(
Top
 Profile  
 
arvika
 Post subject: Re: Noname monolith
PostPosted: November 16th, 2015, 6:32 
Offline

Joined: October 24th, 2009, 15:22
Posts: 917
Location: Poland
So Sandisk pinout will not fit.

_________________
Flash Killer - everyday new resources (pinout, XOR, ECC,config) for flash devices
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 9 posts ] 

Main » Forums home » Flash storage, SSD

All times are UTC - 5 hours [ DST ]

Who is online

Users browsing this forum: gameboybin and 11 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Switch to mobile style
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group