Hello everyone;

I have a monolithic USB PEN DRIVE, it seems that the controller is damaged and i can´t get the dta from it, so i would like to know if there a possibility o recover the data from it. The pictures below shows the type of pen drive that i have. I'm not findinding any kind of way to recover the data from it. Any sugestions?

Thank you very mutch.

A DATA Recovery lab can connect to the round pads and attempt to access the NAND directly. It is a common recovery, though success varies.
If you do not own Flash recovery tools, this is not DIY due to the complexity of wear levelling algorithms, DATA whitening and knowing how to successfully dump the NAND in the first place (pinouts, chip config etc.)

If you say your location, a local DR Lab can be suggested.

http://odzyskiwanie-danych.com.pl/image ... arvika.jpg looks same. My pinout should fit.

_________________
Flash Killer - everyday new resources (pinout, XOR, ECC,config) for flash devices

Yes it is the same. How can i conect it to pc3000. Do you have any suggestion?

thanks.

You will need a thin wires connected to special Monolith adapter this way

_________________
VISUAL NAND RECONSTRUCTOR. Since 2014.

That's a beautiful picture (but I am kinda biased!) Looks like in the process of pinout discovery for the wires to be also on SD Pads

What a beautiful color of wires! I have only one color...

_________________
Flash Killer - everyday new resources (pinout, XOR, ECC,config) for flash devices

You can get cables like that (single strand) from old telephone cables - or new telephone cables

_________________
If you can keep your head when all about you are losing theirs, you probably don't fully understand the situation. ... Mr Kipling

https://www.mjm.co.uk/

I really like and love your work Sasha...

You and arvika (Michal)

Artistic work...

_________________
Kuwait Data Recovery - UNIX GTC
The only reason for time is so that everything doesn't happen at once. By: Albert Einstein

Hi,
You can also use small copper wires from traffo

_________________
RATUJ-DANE odzyskiwanie danych

Rdane .
Can We Have a Link of What you are Referring To

_________________
Regards
Amarbir S Dhillon , Chandigarh Data Recovery Labs [India]
Logical,Semi Physical And Physical Data Recovery
Website-> http://www.chandigarhdatarecovery.com

any thin wires will do, you just need to test to see how well it solders. common places to fild it: in DC power cords, split the strands - generally about .09mm, wrapping wire for transformers etc, can be pretty thin, usb cables, charger cables etc.

Oh ,
Was he referring to enameled copper wire ? i think so this is what he meant

_________________
Regards
Amarbir S Dhillon , Chandigarh Data Recovery Labs [India]
Logical,Semi Physical And Physical Data Recovery
Website-> http://www.chandigarhdatarecovery.com

You can use basically any thin (0.05-0.1mm) enameled copper wire for more precise work, as RDane said.
This wire on picture is a way too thick for smallest monolith pads (vias) with diameter ~0.3mm, but works fine for Sandisk SDs

Thin one looks like this

_________________
VISUAL NAND RECONSTRUCTOR. Since 2014.

From RJ45 we can get even more colors or hue,
or single wire from rj45 will be to tick? I think so, I will check

cat5, cat6 cable way too thick. make sure you test with vernier calipers and make sure wire thickness < 0.1mm