Hi

I have MK5075GSX with dead heads, i replaced heads and after imaging %8 with PC3K only the hard drive just stuck at BSY.

Now the hard drive click 4-5 times and stuck in BSY.

here after powering up

Techno On............................... : Drive is not ready

Zone table.............................. : Zone table read error; Transmission data stop CMD error; Drive is not ready

G-List reading error.................... : G-List read error; Transmission data stop CMD error; Drive is not ready

CP Avalable............................. : 33,34,44,56,92,95,98,9A,9B,9C,A2,A5,A8,A9,AA,AD,AE,AF,B1,B3,B5,B6,BB,BD,C1,C4,C5,C6,C7,C8,C9,CB,CD,D0,D1,D4,D6,D7,D8,D9,DA,DB,DD,E0,E1,E2,E3,F3,F5

I just did
i put the head back on the donor and it works fine.

but on the patient drive still stuck on BSY

usualy after Recalibration the drive get DRD and DSC, and when i try to do any thing like reading the ID it stuck at DRQ

it mostly stuck at BSY after power on. and cannot check g-list while it is stuck in BSY

when i do

Soft reset ...
Hard reset ...
Recalibration attempt .................. : Recalibration error HDD Redynes timeout (10000)
Recalibration........................... : Ok

i get DRD and DSC

after that any thing i do will like reading id or g-list will stuck at DRQ

Clearing the g-list with make it click again and stuck on BSY sometimes and sometimes ERR

Yes i have terminal access

it work now with virtual translator for short time then i have to power of/on the drive + Recalibration to make it DRD and DSC in order to continue and so on