MultiDrive – free backup, clone & wipe disk utility from Atola Technology

Main » Forums home » Conventional hard drives

All times are UTC - 5 hours [ DST ]



Post new topic Reply to topic  Page 1 of 2
  [ 27 posts ]  Go to page 1, 2  Next
  Previous topic | Next topic 
Author Message
sempre
 Post subject: Rosewood
PostPosted: August 28th, 2017, 14:11 
Offline
User avatar

Joined: October 14th, 2005, 9:26
Posts: 1060
Hi to all! :mrgreen:


HDD ON
" No Clicking "
IS LOG

Boot 0x80M
Tech Unlock Handshake: 0x30A62C32
Reply:

ctrl+z
is log

QB
Rst 0x80MSrv DETCR init 0x0000
(P) SATA Reset

CTRL+Z
is log

RAW OFF
PASS
(DOS Table) Worst Count: 00000000 At SU: FFFFFFFF NT: 00000000 OT: 00000000
PrgF
(MC POR Duration): 00000007AC
Intel 6G->3G
Send Status: COMRESET seen
CSpd= 3Gbps
DSC
ASCII Diag mode

F3 T>

ctrl+a
is log

Prod Desc: CheopsAM.1.0.SATA.Rosewood.Mule.Servo376.Rap30.AP1.4K + SMR Despo DFW
Package Version: RW07A8.SDM2.AA6973.SBM3
Serial #: W9318D7K
Changelist: 00997909
Model #: ST1000LM035-1RK172
ID: 101
Servo FW Rev: 8ACE
Heads: 2
PCBA SN: 0000K645KLPB
Default factory config: SD&D
Active config: SD&D

TotalHostWrites 00000000
NumberOfSegWrites 0000
TotalHPCBROs 00000000
TotalBWOs 00000000
MCMTWrites 00000000
Idle1Count 0000
MCSegmentUsed 0000
MCNodeUsed 00000000

is not id hdd, is not access sa.

help? :idea:

_________________
Нет ничего невозможного
Top
 Profile  
 
sempre
 Post subject: Re: Rosewood
PostPosted: August 28th, 2017, 16:02 
Offline
User avatar

Joined: October 14th, 2005, 9:26
Posts: 1060
please look!

Rd Sys File: vol = 3, FID = 181, Copy = 000...
Receiving file FILE_3_181_0, length = 40960

COM transfer baud rate set to 115200
Wr Sys File: vol = 3, FID = 181...
Unsupported by FW!
Wr Sys File: vol = 3, FID = 181...
Unsupported by FW!
Rd Sys File: vol = 3, FID = 093, Copy = 000...
Receiving file FILE_3_093_0, length = 8192
SMP Dbl: 0x3C001000 - 0x0001FFFF (0x0000000F)
Wr Sys File: vol = 3, FID = 093...
Unsupported by FW!
Rd Sys File: vol = 3, FID = 093, Copy = 000...
Receiving file FILE_3_093_0, length = 8192
SMP Dbl: 0x3C001000 - 0x0001FFFF (0x0000000F)
Rd Sys File: vol = 3, FID = 093, Copy = 001...
Receiving file FILE_3_093_1, length = 8192
SMP Dbl: 0x3C001000 - 0x0001FFFF (0x0000000F)
Wr Sys File: vol = 3, FID = 093...
Unsupported by FW!
Rd Sys File: vol = 3, FID = 093, Copy = 001...
Receiving file FILE_3_093_1, length = 8192
SMP Dbl: 0x3C001000 - 0x0001FFFF (0x0000000F)

Executing user command.................. : Show Alt-List
ASCII Diag mode

F3 T>/

F3 T>
Error switching COM port baud rate
Unlock Tech Mode, drive prepared by utility : Ok

_________________
Нет ничего невозможного
Top
 Profile  
 
Masterclass
 Post subject: Re: Rosewood
PostPosted: August 29th, 2017, 0:56 
Offline

Joined: May 29th, 2011, 8:47
Posts: 141
Location: Russia
What seems to be the problem finally?
Top
 Profile  
 
sempre
 Post subject: Re: Rosewood
PostPosted: August 29th, 2017, 7:18 
Offline
User avatar

Joined: October 14th, 2005, 9:26
Posts: 1060
Masterclass wrote:
What seems to be the problem finally?



still do not know !! SA? :?:

_________________
Нет ничего невозможного
Top
 Profile  
 
darkforce1
 Post subject: Re: Rosewood
PostPosted: August 31st, 2017, 0:38 
Offline
User avatar

Joined: June 27th, 2005, 8:27
Posts: 615
Location: India
Translator

_________________
DF :)
www.datatracksystem.net
Top
 Profile  
 
Masterclass
 Post subject: Re: Rosewood
PostPosted: August 31st, 2017, 0:58 
Offline

Joined: May 29th, 2011, 8:47
Posts: 141
Location: Russia
darkforce1 wrote:
Translator

How do you come to this conclusion?
Top
 Profile  
 
sosrecup
 Post subject: Re: Rosewood
PostPosted: August 31st, 2017, 3:17 
Offline

Joined: September 7th, 2012, 16:37
Posts: 197
Quote:
Unlock Tech Mode, drive prepared by utility : Ok


The drive has SA issue and can't initialize.


Did you try to Unlock tech mode?

if yes, try to refresh the drive ID.

HTH
Top
 Profile  
 
colanco
 Post subject: Re: Rosewood
PostPosted: August 31st, 2017, 5:43 
Offline

Joined: December 6th, 2012, 8:49
Posts: 291
Location: españa
Rosewood...... Another wonderful product from the SEAGATE factory .......

With each new product, new "scrap"..... (and being generous)
Top
 Profile  
 
lcoughey
 Post subject: Re: Rosewood
PostPosted: August 31st, 2017, 6:39 
Offline
User avatar

Joined: February 9th, 2009, 16:13
Posts: 2574
Location: Ontario, Canada
Sadly, most of us wouldn't have much work if it weren't for seagate.

_________________
Luke
Recovery Force Data Recovery
Top
 Profile  
 
agent007
 Post subject: Re: Rosewood
PostPosted: August 31st, 2017, 6:56 
Offline

Joined: July 17th, 2017, 2:32
Posts: 27
Location: Singapore
Very soon we will have an equivalent 1TB from WD too, my guess the quality should have much much better than Seagate.
Top
 Profile  
 
Amarbir[CDR-Labs]
 Post subject: Re: Rosewood
PostPosted: August 31st, 2017, 7:37 
Offline
User avatar

Joined: August 15th, 2006, 3:01
Posts: 3522
Location: CDRLabs @ Chandigarh [ India ]
agent007 wrote:
Very soon we will have an equivalent 1TB from WD too, my guess the quality should have much much better than Seagate.


Well,
The Firmware in Rosewood is a Little Bit Different According To Ace .Stuff Like SMP Etc Is Still Not Implemented .The SA Structure of the WD HDD is Very Different should be easy to recover then this POS

_________________
Regards
Amarbir S Dhillon , Chandigarh Data Recovery Labs [India]
Logical,Semi Physical And Physical Data Recovery
Website-> http://www.chandigarhdatarecovery.com
Top
 Profile  
 
colanco
 Post subject: Re: Rosewood
PostPosted: August 31st, 2017, 7:50 
Offline

Joined: December 6th, 2012, 8:49
Posts: 291
Location: españa
lcoughey wrote:
Sadly, most of us wouldn't have much work if it weren't for seagate.


Yes, more work, for sure!!!

But the work/cash ratio will be much lower (at least in my case)

And it is not a problem of the firmware lock, that only opens the doors to hell.......
Top
 Profile  
 
sempre
 Post subject: Re: Rosewood
PostPosted: August 31st, 2017, 8:18 
Offline
User avatar

Joined: October 14th, 2005, 9:26
Posts: 1060
sosrecup wrote:
Quote:
Unlock Tech Mode, drive prepared by utility : Ok


The drive has SA issue and can't initialize.


Did you try to Unlock tech mode?

if yes, try to refresh the drive ID.

HTH


Yes not ID!!

_________________
Нет ничего невозможного
Top
 Profile  
 
sempre
 Post subject: Re: Rosewood
PostPosted: August 31st, 2017, 8:19 
Offline
User avatar

Joined: October 14th, 2005, 9:26
Posts: 1060
Masterclass wrote:
darkforce1 wrote:
Translator

How do you come to this conclusion?


Do not record anything on SA!

_________________
Нет ничего невозможного
Top
 Profile  
 
pepe
 Post subject: Re: Rosewood
PostPosted: August 31st, 2017, 8:23 
Offline

Joined: October 3rd, 2005, 0:40
Posts: 4754
Location: Hungary
these drives are lacking the command to write sysfiles, so don't expect too much from pc3k.

_________________
Adatmentés - Data recovery
Top
 Profile  
 
sempre
 Post subject: Re: Rosewood
PostPosted: August 31st, 2017, 8:38 
Offline
User avatar

Joined: October 14th, 2005, 9:26
Posts: 1060
pepe wrote:
these drives are lacking the command to write sysfiles, so don't expect too much from pc3k.

:shock:

_________________
Нет ничего невозможного
Top
 Profile  
 
MindMergepk
 Post subject: Re: Rosewood
PostPosted: August 31st, 2017, 9:00 
Offline
User avatar

Joined: December 8th, 2013, 4:48
Posts: 838
Location: Pakistan
pepe wrote:
these drives are lacking the command to write sysfiles, so don't expect too much from pc3k.


there is a way to write sysfiles with pc3k to these drives. :idea:

_________________
Data Recovery Pakistan
Top
 Profile  
 
sempre
 Post subject: Re: Rosewood
PostPosted: August 31st, 2017, 9:10 
Offline
User avatar

Joined: October 14th, 2005, 9:26
Posts: 1060
MindMergepk wrote:
pepe wrote:
these drives are lacking the command to write sysfiles, so don't expect too much from pc3k.


there is a way to write sysfiles with pc3k to these drives. :idea:

:?: :?:

_________________
Нет ничего невозможного
Top
 Profile  
 
Amarbir[CDR-Labs]
 Post subject: Re: Rosewood
PostPosted: August 31st, 2017, 9:50 
Offline
User avatar

Joined: August 15th, 2006, 3:01
Posts: 3522
Location: CDRLabs @ Chandigarh [ India ]
MindMergepk wrote:
pepe wrote:
these drives are lacking the command to write sysfiles, so don't expect too much from pc3k.


there is a way to write sysfiles with pc3k to these drives. :idea:


Hi,
Is that so i Need To Ask TS Support From Ace again Is This is The Case

_________________
Regards
Amarbir S Dhillon , Chandigarh Data Recovery Labs [India]
Logical,Semi Physical And Physical Data Recovery
Website-> http://www.chandigarhdatarecovery.com
Top
 Profile  
 
sempre
 Post subject: Re: Rosewood
PostPosted: August 31st, 2017, 9:52 
Offline
User avatar

Joined: October 14th, 2005, 9:26
Posts: 1060
Wait TS Ace!!
Thanks!

_________________
Нет ничего невозможного
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 2
  [ 27 posts ]  Go to page 1, 2  Next

Main » Forums home » Conventional hard drives

All times are UTC - 5 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 97 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Switch to mobile style
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group