Thanks for all replies. I am new as i said before.
Spildit wrote:
Forget about those MRT guys and outsource the drive to someone with more experience to recover the data from it ....
I know . But money problem..)
Spildit wrote:
I learned . Thanks
Spildit wrote:
If this were a drive that i were attempting to recover i would :
Option 1 - Plug by TTL to USB PCB pins and attempt to read module 02. If Access is granted i would patch 02 and clear Re-Lo. Power off/on. Image by USB.
Option 2 - Use a SATA PCB. Move ROM content either by external programmer, moving chip or reading ROM by USB if possible (or TTL if available). Now with SATA PCB try to initialize dir + module 11, etc ... Can you gain access to SA to patch 02 and clear re-lo ?
If the drive does ID properly ... SOMETIMES ... It does mean that you still have access to undamaged overlay and firmware ... I would vote for considerable amount of bad sectors.
Hopefully head(s) are still ok and the slow issue patch will allow you for imaging/cloning.
Now ... If you can't do that by USB you might need to deal with decryption later on ...
.
I will search about how can I try this options.
....
Quote:
- Normal. How are you connecting the drive to MRT ? By .... USB ? If the drive is stuck in BSY you will have trouble with SATA even more with .... USB !!!
Or are you plugging the drive to the USB port of the computer and wishing that MRT do see the drive ?
yes . MRT see it.
Quote:
If you can see it with MRT DE at least you should have connected it to MRT somehew ... Most likely if you are using USB you can't send VSCs to the drive with MRT and that is why you can't see modules .... Assuming that you have some sort of adaptor to connect the USB drive by ---- USB ? To MRT ?
No computers USB Port. I can see all with MRT DE, Only WD USB for fixing sections
Quote:
- Can you explain EXACTLY what you have done here ? How did you ... HOT SWAP this one ?
U12 chip swap from 2060-771961 USB pcb to 2060-771960 Sata Pcb
I have TTL Uart usb adaptor. But i cannot use it properly. I dont know why. Sometimes working. Sometimes not. But how do I connect with this HDD. Tehre is no com port
Thanks for all . I will try to learn your advices.