I pressed CTRL+V thinking I could paste here. I believe that's what cause the 2 following lines.
Code:
F3 T>
EchoInterfaceCmds: On
EchoBackgroundActivities: Off
F3 T>F"SerialDebugLevel",7F
Drive AMPS Configuration has been modified from compiled defaults.
Drive must be re-initialized to controller firmware defaults by re-downloading controller firmware
DO NOT SHIP WITHOUT FIRST RE-DOWNLOADING CONTROLLER FIRMWARE OR RESETTING TO DEFAULTS!
Update HPA Cap and Save
(D) SATA Reset
Byte:0487: SerialDebugLevel = 7F
F3 T>
THIS IS THE SECOND SPIN UPCode:
Trans.
Spin Up
SpinOK
TCC:0015
(P) SATA Reset
RAW OFF
PASS
Drive AMPS Configuration has been modified from compiled defaults.
Drive must be re-initialized to controller firmware defaults by re-downloading controller firmware
DO NOT SHIP WITHOUT FIRST RE-DOWNLOADING CONTROLLER FIRMWARE OR RESETTING TO DEFAULTS!
MCMainPOR: Start:
User Data Base 004403D8
Check MCMT Version: Current
MC026: Reconstruction: MCMT Reconstruction Start
[RSRS] 000D
MC022: Reconstruction: HeadPtr was unwritten
MC024: Reconstruction: Completed:
[MCMTWS] Tail/Head 000D 000D
MCMainPOR: MCTStateFlags 0000002A MCStateFlags 00000041 Tms 000000C2
SP200: MSPMainPOR Start
MSP MainPOR: 00003000 Tms 000000C2 00000092 0000016B
MSP MainPOR: Complete
No Phy: Staggered spin bypass