Hello everyone
I need your advice

I bought a pcb to replace one that was out of order on a 2.5" hard drive.

I need to clone the bios from the old one to the new one, the solution would be to unsolder it and resolder it on the other one, but not being a great solderer, I'm looking for another solution.
I've tried using a CH341A clamp, but the one I bought isn't very good.
Do you have another serious solution or a serious supplier who sells this type of pliers.

Thank you for your advice.

Use a pogo pin cable.

_________________
A backup a day keeps DR away.

You can do what fzabkar said, or you can take it to a repair shop and they will perform that for you. It will cost you 5€ and 2 minutes.

_________________
BTC Wallet - 3AoQPTBsz9PbfoanCx44Lw76Y2TwtKa1x5
Instagram https://www.instagram.com/datarecovery_morde.pt/