Hello to all Gurus

I have a WD400BB hard disk. Detects Ok but when i try to access the data it gives ABR and ERR signal and when I do Module check it gives error on Module 32 (Translator).

Do i have to regenerate translator. Please guide.

DF

Hi,
-Backup SA
-Clear G-List
-Regenerate Translator

*Header on Module 32 must be OK...

Mikippp

Thanks you MikiPPP sir

DF

Before doing what U said when i try to read module 32 it goes till 75% and then gives " Module read error physical read error C/H/S -2/0-508 Techno CMD sending Device Error Detected 51/04 ABR read error " so it it a header problem or there is Bad Sector in SA.

and will your (Mikippp) meathord work.

Thanks

DF

Please read -2/0-508 Techno as -2/0/508

Guys ,
You Know Whats The Greatest Thing .When You Regenerate The Translator ,The Data Is Visible ,Why ?

1 :How Does The Regeneration of Translator Make Sure You Can Access The Same Sectors Which Have The Data .Even 1 Sector Misplacement Will Make Data Useless .This is a Beautiful Algorithm .Really Beautiful

_________________
Regards
Amarbir S Dhillon , Chandigarh Data Recovery Labs [India]
Logical,Semi Physical And Physical Data Recovery
Website-> http://www.chandigarhdatarecovery.com

Darkforce did you mange to get drive to work? i have same problem Module read error physical read error C/H/S?