View topic - MAXTOR 160GB Q500 is burning PCB301599100

Main » Forums home » Conventional hard drives

All times are UTC - 5 hours [ DST ]

MAXTOR 160GB Q500 is burning PCB301599100

Page 2 of 2

[ 22 posts ]

Go to page Previous 1, 2

Previous topic | Next topic

Author

Message

gsimon

Post subject: Re: MAXTOR 160GB Q500 is burning PCB301599100

Posted: April 1st, 2008, 7:37

Joined: October 7th, 2005, 2:03
Posts: 152
Location: serbia

romarosa wrote:

Thank you very match.
Drive spinning OK. (label stick on connector interface IDE is no identic like ORIGINAL: J4FYA and tested: M6FYA)
Is it OK?
Can you help my with SA access for Maxtor , please ? I have schematic diagram - pin layou interface for comunications with drive in SA, but for SEAGATE only.

One question more :

what processor is on J4FYA...........Ardent C8-C1? Or other?

_________________
Spasavanje podataka

Top

b4b446

Post subject: Re: MAXTOR 160GB Q500 is burning PCB301599100

Posted: May 23rd, 2008, 14:40

Joined: May 23rd, 2008, 14:32
Posts: 3

I have same board, and it was damaged when I moved. I was wondering if somebody could determine the what part was knocked from the board. I have located the pads, and they are located to the right of the large chip, next to the cap labeled C3O1U. Any help is unappreciated. Can provide picture if needed.

Top

Page 2 of 2

[ 22 posts ]

Go to page Previous 1, 2

Main » Forums home » Conventional hard drives

All times are UTC - 5 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 40 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum