Hello everybody.

I have Seagate drive that makes one knock and stays BSY.

PC3K Terminal output:

when I tried and it says:


Model: ST3500641AS
F/W: 2.AAA
DateCode: 06132
SiteCode: AMK

Any ideas weather it can be fixed with PC3K utility or does it need head/controller replacement?

Thanks for any response.

Application code cannot be read. Try using a loader.

Best regards,

Dobre

_________________
Murphy was an optimist

Datarecovery in Belgium, Holland, France and Germany
Datarecoverytools http://www.drtools.eu

Are you 100% sure this if the ORIGINAL PCB?

_________________
PC Image Data Recovery
http://www.pcimage.co.uk

New!! HDD-PCB.COM for all your PCB and donor HDD requirements!

void message

That's a valid question: app code mismatch with flash ROM can indicate the board was swapped. You can try copying the ROM from same drive and firmware onto the current PCB but, if it turns out PCB is not original, always best to get hold of original.

I dont think this is a problem of pcb mismatch i think APP code is corrupted .

PCB flash problem, write the flash can be solve the problem



Sunny

_________________
data recovery service[/b]

Thanks for all replies. I do not know if this is original PCB, that was my first thought when I saw "Application code incompatible with serial flash code". Will try to get replacement controller and check that (it is not very urgent). Otherwise I will use new drive to create loader and try it that way.