General (and not general)Seagate questions - for everyone :)

[N.C.]

Also try to look at this post:
7200-stuff-mess-t12153.html#p79225
It may help you....Or try to rewrite the 4 sector of vendor track...
Rgds

Unfortunately not works, this is a 7 series drive....
I have the Salvation Seagate Doctor only, wich is a s**t.
I have no backup from the vendor track, only the modules, wich is in the tool.

So, maybe the 4 sector is inside somewhere in the modules, but this takes too much time to invetigate how can i select this and where to write up.

[drc]

Check your PM.

[N.C.]

Got it, thanks.

[rameez]

try F,,1 instead of F
that will set stuff values no matter what .

[drc]

Another answer is that salvation tool backs up 4th sector of vendor track as a "module", they just call it something silly and don't mention it anywhere.

[N.C.]

Gurus,

I am searching for loader or modules or any resources for snowmass (barracuda IV) 80GB AMK 3.10.
If you have any for this, please let me know

Thanks.
Janos

[N.C.]

problem solved without resources.
Thank you for who taking time to check it for me....

[pclab]

Hi

I have the same problem:

Interface task reset
4096k x 16 SDRAM
TONKA15 - 1_Disk S.68 03-14-06 11:17

Buzz - Head Mask FFFF - Switch to full int.
Spin Ready
(P)SATA Reset

Stuff Was Unreadable3.AAH 03-14-06 11:19 AAH,35_S_5_S1,4T
(
T>

Does anyone have a FW for this model?
What should I put on the ASCIFE command, to do a "manual" reset? Where do I get that info?

Thanks

[hddguy]

What are you using for repairs? Also what is complete model, you will need to match capacity also if you plan to replace STUFF info.

[pclab]

Hi HDDGUY

I'm using SD Doctor.
The disk is a Barracuda 7200.9
P/N: 9BD133-304
FW: 3.AAH
Data Code: 06365

Thank You

[rameez]

ASCIFE dont work on this model , rewrite vendor track of any hdd of same model .

[pclab]

I think it's solved.

Uploaded the module INFO, and I already could do a Surface Scan.

I just need to connect it to a PC (they are all busy now...) to check if it's OK.