Damage Fujitsu hard drive to repair

[craigdf]

Hi
I have got an Fujitsu 120GB 2.5" IDE hard drive. Model Number: MHT2120AT. The hard drive 5 volts got connected to 12 Volts and an IC on the PCB has Blown. Does anyone know what the IC is and can I replace it?

The IC is next to the coil and is an 8 pin IC - I think it is an voltage regulator???

I have attach an image of the PCB

Also there is an short between the 5volts to GNd

thanks

Attachments

[unknown]

Check TVS or replace the entire PCB with matched one and transfer the original ROM to the donor PCB.

Good luck

[mr_spokk]

Try to check the fuse.

Bosse

[img]

DSC03618.jpg

[/img]

Attachments

[craigdf]

Hi
Thanks for the info.
The fuse is ok. I think the isue is the IC near the coil

does anyone know what the IC is and where I can get a replacement