ppumkin wrote:
@Modo - Pre amp has nothing todo with the motor.
The chip you are trying to repalce is a phase controller for the stepping motor- This is not connected to the heads but might return data for rpm from motor- depends on spec sheet of IC. What causeds this type of blow out can be a bad transistor!and sometimes other diodes sonnected to it.BUT WHY is another question. if you replace this chip it wil blow AGAIN and AGAIN and AGAIN! You need to trace WHY its blowing.
The original baord has an issue somewhere- the fact that the repalcement baord spins the motor up is ok. And if you replaced the rom too and it does not read- then you will have an issue with the heads inside the drive - caused by the same surge that blew your motor chip. Because it cannot read the SA and cannot INIT the drive.
Dont open your drive if you want your data. You did as much as you could man. Take the gurus advice and save up. Sorry mate.
Thank you for that information!
I will give up now :-/
Sorry for trying to be smart a.s
I thought pre amp is the motor.
Alright then. A pro would open the Hdd and replace the entire head, and the pcb right?
Don't worry, I won't do that.
I think my conclusion is to save up, and probably never buy a WD again. Which is sad.
unfortunately one wd hdd has warranty until 2012.. so I get two years at the max.