I have a WD pcb that is burnt out. On the actual PCB it is printed with 2060-701335-005 REV A, However the white sticker says 2061-701335-D00 AD and then some other stuff underlined.

If i was to look for a pcb to replace mine, which code should i be searching for? I also understand i need to change my u12 chip from the old pcb to the new one.

Also, I have another similar hard drive that has a similar pcb.

2060-701335-003 rev b is printed on the board
2061-701335-000 AG is on the white sticker.

would this be good enough pcb to switch the u12s??

Hi.

Yes it should do.

_________________
http://www.northwind.gr
SandForce SSD Recovery
Ransomware Reverse Engineering - NoMoreRansom! partners

No it wont because your drive is Hawk and the donor drive is Sabre58 these pcbs looks same but they are no interchangeable .

It has worked for me in the past just fine.

_________________
http://www.northwind.gr
SandForce SSD Recovery
Ransomware Reverse Engineering - NoMoreRansom! partners

you have to care about 701335 only xxxxx-701335-xxx in all Wd pcb except 701640 . care about 701640-002 or whatever

_________________
Tawfeek Mokhtar
http://alsafwapc.net
Alsafwa Data Recovery Egypt

Ok lets see if it works or not .