I have a 500 and the hard drive can not be detected

Through this method, the terminal did
Please guide me please

Boot 0x10M
Spin Up[0x00000000][0x0000B67C][0x0000BA10]
Trans.

Rst 0x10M
MC Internal LPC Process
Spin Up
(P) SATA Reset

MCMTFileHandler: EXCEPTION: Failed MCMT read request
MCMTFileHandler: EXCEPTION: Failed MCMT read request
ASCII Diag mode

F3 T>/2

F3 2>U

Spin Up Complete
Elapsed Time 0.000 msecs
F3 2>Z

Spin Down Complete
Elapsed Time 6.032 secs
F3 2>U

Spin Up Complete
Elapsed Time 3.703 secs
F3 2>
ASCII Diag mode

F3 T>m0,2,2,,,,,22
Max Wr Retries = 00, Max Rd Retries = 00, Max ECC T-Level = 1C, Max Certify Rewr
ite Retries = 0A8F

(DOS) Requesting File Save

User Partition Format Successful - Elapsed Time 0 mins 00 secs
Zone re-format was skipped.
F3 T>/1

F3 1>N1

Clear SMART is completed.
F3 1>
ASCII Diag mode

F3 T>i4,1,22

F3 T>

Were there any entries in Non resident Alt List before you ran m0,2,2,,,,,22?

If this is a direct screen dump, your have done some of this in the wrong order. Running m0,2,2,,,,,22 if there are still entries in Alt List is not the best way of doing this. By running i4,1,22 you have now cleared the Alt List too.

_________________
If you can keep your head when all about you are losing theirs, you probably don't fully understand the situation. ... Mr Kipling

https://www.mjm.co.uk/

It's a more complete explanation did not notice

I gave the wrong command?

Or gave orders to move?

If you did the commands in the sequence above, then that has not helped the situation. can you get to T>
then type V40

put the result here

then do the same for V4

_________________
If you can keep your head when all about you are losing theirs, you probably don't fully understand the situation. ... Mr Kipling

https://www.mjm.co.uk/

Hello
The commands you use are correct . but the procedure is wrong.

1. i4,1,22
2. m0,2,2,,,,,22
3. N1
but your hdd need only read channel short after complete calibration, until ready status. Because it was giving MCMT read request failed.
http://hddrepairing.com/forums/viewtopic.php?f=44&t=35

Regards
Waqas Ali

F3 T>V40
Nonresident GList 1 entries returned
Total entries available: 1
PBA Len Flags Phy Cyl Hd PhySctr SFI
245CB8D 1 20 ED72 1 109 75461

I think the translator is damaged now. The best thing to do in this instance is copy back translator and smart modules from backup and check V40 and V4 again and put results here.

_________________
If you can keep your head when all about you are losing theirs, you probably don't fully understand the situation. ... Mr Kipling

https://www.mjm.co.uk/

Rst 0x10M
MC Internal LPC Process
Spin Up
(P) SATA Reset

MCMTFileHandler: EXCEPTION: Failed MCMT read request
MCMTFileHandler: EXCEPTION: Failed MCMT read request
ASCII Diag mode

F3 T>V40
Nonresident GList 1 entries returned
Total entries available: 1
PBA Len Flags Phy Cyl Hd PhySctr SFI
245CB8D 1 20 ED72 1 109 75461

F3 T>V4

Reassigned Sectors List
Entries: 0000, Alts: 0000, Removed: 061C, Pending: 0000

Idx LBA PBA LLLCHS of LBA PLPCHS of PBA SFI Hours Msecs S
tatus BBM Mask
F3 T>

hi
mc-recovery pls put ROM file this HDD for me
I have two Hdd of this model and firmware is crashed and I want ROM file for programing. by programmer. if 8pin on PCB
pls upload ROM file of backup if 8 pin on pcb

restore the translator and SMART modules from your sa backup. Then post the V logs

_________________
If you can keep your head when all about you are losing theirs, you probably don't fully understand the situation. ... Mr Kipling

https://www.mjm.co.uk/

How restore the translator and SMART modules from your sa backup????

Yepp, thats the 100$Billon question, as I assume that with that question you don't have a SA-Backup.
Now things got from bad to worse, my only advice is to take it to a pro.

_________________
Rescue IT Datarecovery service Sweden
Rescue IT Dataräddning Göteborg AB
http://www.rescue-it.se

F3 1>N1

DiagError 00012001

F3 T>V40
Primary DST List 0 entries returned
Total entries available: 0
PBA Len Flags Phy Cyl Hd PhySctr SFI
Nonresident GList 0 entries returned


F3 T>V4

Reassigned Sectors List
Entries: 0000, Alts: 0000, Removed: 4012, Pending: 0000

Idx LBA PBA LLLCHS of LBA Wdg PLPCHS of PBA SFI Hours Msec
s Status BBM Mask