Yes, they are.

Yes, they are, but only on the SSD, not on the RAID drive.

I didn't realize that it showed that the messages had been edited when I edited my posts on this forum, and since I needed you to read edited messages, I had to mention that they had been edited. But now that I know the forum indicates when a message has been edited, I don't need to do that anymore.

And I won't do it.

You have two drives in your computer, an SSD and an HDD.

What RAID drive are you talking about?


So you can see your files on the SSD.
This means no array is configured.
Show the partitioning of the second disk in DMDE.

There is a damaged partition on the SSD (B red mark - volume boot sector), you need to repair it (which is risky without making a disk copy), or recover the data immediately (for example via DMDE), which is also risky without a disk copy.

Or maybe I don't understand something...

_________________
Data recovery Poland (RAID, HDD, SSD) - https://hex-serwis.pl

This is the Seagate ST1000DM003-1SB102 1,000.2 GB SATA III 6 Gb/s internal HDD. As I have already mentioned, this is not the HDD I used to create the RAID. I will show its partitioning in DMDE in the attached images, in chronological order from bottom to top.

I don't understand... Why are you showing devices that aren't affected by the problem?
You were supposed to post a screenshot of the main partition window, not everything you deem appropriate - these screenshots are useless...

I'm afraid I can't help you remotely, your descriptions are too chaotic.

_________________
Data recovery Poland (RAID, HDD, SSD) - https://hex-serwis.pl

The SSD shown was affected by the problem. I showed that HDD because I believed you wanted me to do that, and I will also show the affected HDD. How can I identify the affected HDD if I don't remember which one it was?.

How can I display the main partition window in DMDE? Please explain it in a way that someone with no computer knowledge can understand. Please forgive me for copying what I copied; I believed I was helping. From now on, I will ask what you want me to show before showing it, so I don't show unnecessary information.

Now I don't understand at all.
You wrote that your drives are in a RAID 0 array: SSD+HDD:


Which turned out to be false, at least based on all the information you provided.

Now you write that:

We're supposed to know which of your devices is failing, what you did during/after the failure, and finally, you write that the problem is with the HDD.

What is the main problem or which device is affected by the problem?

This is the main partition window in DMDE:

_________________
Data recovery Poland (RAID, HDD, SSD) - https://hex-serwis.pl