I have a Maxtor onetouch III, no partition is found, the drive is RAID but not sure Raid 0 + 1 or else. Does anyone know how to get the data ? I am using Rstudio but dont know hot to configure the RAID settings. Thanks.

Your better off using Winhex. Use trial and error to find correct block size.

Hy terranova, hr u?

wich File system use this RAID ?,

Best regards friend

Sincerlay

Alberto

hi Beto, great...thanks.... the filesystem is NTFS.

RStudio can determine the strip size, offset, etc. with just a few clicks. It's pretty much menu driven - If it returns a no confidence state, then increase the number of samples (i.e. read more of the drive).

_________________
http://www.datasaversllc.com

Hi,

How many drives do you have in the RAID set?
This will help determine what for a RAID set you have. If you have only 2 Drives, then it can only be RAID 0 or RAID 1. If you have 3 or more drives then it most likely is RAID 5, but It also could be RAID 0.

If you have RAID 1 (mirrored disks)
then all data will be mirrored on the second drive, therefore one drive should be mountable and have all the data, therefore no DR is needed.

If you have RAID 0 (striped disks)
then you need to image the drives as virtual drives in R-Studio (Virtual strip set) or any other software for that.

thank you guys for all your help, i will try.