Hi to all,

I am doing some research in a hitachi notebook Head Swap.

I am matching a lot almost everything but i still can not be 100% sucess with this.

In the picture i use the same model and with the same MLC, when change heads can not have ID.

Puting the heads back in the donor i can get ID.




Anyone have made this 100% sucess.

Would like to know if anyone have a good opinion in this.

Thanks
ZeBong

_________________
ZeBong
" что случилось в России - останется в России "
" Россия еще раз"

Just match model, part number and MLC (but not critical) you should then have 100% success.

You've got it turned around.

These should be a match, but you'll need a 160 GB donor drive. A 120 is missing one of the heads.

Jon

_________________
http://www.datasaversllc.com

This case i had clone the head 0 1 3, just need the head 2, and i can do it witht the 120gb, but have problems ....

_________________
ZeBong
" что случилось в России - останется в России "
" Россия еще раз"

some of the 120G models have 4 heads too, but I could not find how to rule it out by the MLC (I must admit I did not check many drives, only a few.)

pepe

_________________
Adatmentés - Data recovery

We do the same thing frequently, and it almost always works. Check PCB number as well - they should match.

_________________
http://www.datasaversllc.com

Thanks to all for helping

_________________
ZeBong
" что случилось в России - останется в России "
" Россия еще раз"

What was the result?

Is doing very very slow , but is going

Thanks NC

_________________
ZeBong
" что случилось в России - останется в России "
" Россия еще раз"